Eagle-i

The Eagle-i has landed! This new addition to the Sinetica brand of power monitoring and control products is the revolutionary development we have all been waiting for. The Eagle-i is a network attached device, designed to provide room or multi rack level power, environmental monitoring and physical access control, using a single IP address. The exciting development to this product is the ability to extend the functionality of the base unit by adding external expansion devices, allowing a further increase in the supported number of sensor inputs, power monitoring inputs and controlled relay outputs, allowing greater flexibility.

• Supplied as 19" rack mountable unit, housed in a 1U metal case.
• Dual mains feed with dual built in power supplies.
• Built in support for:
  • Six power strips / CL-Amps, monitoring Amps, Volts, kVA, kWHr, power factor and frequency
  • Twelve input sensor channels; namely temperature, humidity, voltage free contact and 0-10VDC analogue input.
  • Two Sinetica serial keypads / smart card readers or two external expansion units
  • Two normally open / normally closed relay contacts with a 240VAC voltage switching contact rating.
  • Two normally open / normally closed relay contacts with a low voltage switching 50VDC/AC contact rating.
  • One 12VDC output @ 500mA power supply for solenoid door lock activation.
  • Alarms can be used to trigger SNMP traps, e-mail messages, or SYSLOG events.
• The overall system is controlled and monitored over a TCP/IP, 10/100Mbps Ethernet network with network access provided through SNMP, HTTP, HTTPS and Telnet.

The Eagle-i supports the following external expansion units:

1. Input Expansion Unit. A self contained 1U unit, supporting 12 additional sensor inputs and 2 relay outputs. This, including the 12 input channels and the 2 relay outputs of the base unit, allows the monitoring of a total of up to 24 sensor inputs and 4 relay outputs.
2. Output Expansion Unit. A self contained 1U unit, supporting 12 additional relay outputs rated at 12VDC at 1 Amp / 240VAC at 1 Amp. This, including the 4 outputs of the base unit, allows the monitoring of a total of up to 16 relay outputs.
3. Access Control Expansion Unit. Connected via a serial communication bus, this 1U device is used to control physical access to room or cabinet doors, by supporting six serial ports, and six controllable relay outputs, used for interfacing to the Sinetica range of access control RS485 keypads and card readers.
4. Power Monitoring Expansion Unit. This is a 1U self contained unit, supporting 18 additional power strips or CL-Amps. This, including the 6 power strips of the base unit will allow a total of up to 24 power monitoring devices to be connected.